Use this adapter to charge your non Traxxas ID batteries on your Traxxas ID charger. The Traxxas Connector will plug into the charger, giving you a JST Connector to connect to your battery. Then use the JST-XH balance port on the front of the Traxxas ID charger to plug in your battery’s Balance Plug (if applicable).

Specifications:

Wire Length: 20cm (approx. 8″)
Wire Gauge: 20AWG
Adapter Use: Charging Only
Max Current: 8Amps

Notes:

  • This is NOT a high current adapter for use between an Electronic Speed Controller (ESC) and Battery.
  • This adapter uses 18AWG wire and is for charging only, up to 8Amps.
Package Weight 0.05 lbs
Package Dimensions 5 × 3 × 0.5 in

1 review for Traxxas TRX Female to JST Male: Traxxas ID Battery Charger Charging Adapter (Leads Cables Wires Plugs Connectors) (Receiver Rx Pack)

  1. Nivlong

    Seems to be wired correctly with good quality. I was hoping to use this to charge an SCX24 with a Traxxas (Lipo) charger. However, I made a mistake and confused JST with JST PH (which is what I needed). Oops!

Add a review

Your email address will not be published. Required fields are marked